All replies telling you to heat it are wrong.

That simply won't work, by the time you heat the cart up, anything that is liquid will leak. You cannot heat the carts up too hot otherwise the contents are forced out the bottom.

What you need to do in future is decarb the live resin, there are various ways to remove terps from the extract first before decarbing, but you have to be careful NOT to include any of the extract and ONLY there terps.

If there is any crystals in the terps you remove, it will re-seed the extract and it will crystalize again.

You can use a 100% live resin mix in your cart after decarbing, but it's advised to add 20-30% distillate, otherwise the cart will likely clog before you finish it.

You'll also need to re-add terps as the flavour will be lacking if you didn't remove the terps before decarbing.

I wouldn't use some random diluent off the internet, lots of those have very very nasty shit in including some of the top websites everyone mentions on here constantly.

I also can't advise anywhere to buy them as I don't know any legit sources, so I'm sorry about that. Good luck with the carts.

And one more thing, make sure that before you add the decarbed extract+dist to carts that it doesn't FIZZ up. If it's not decarbed properly, then the extract will fizz up when it's heated up/cooled off in the cart. This can ruin your entire batch of carts.

DO NOT BUY A HEATED CART FILLER. They are fiddly, expensive and a waste of time. You'd be better off filling with a syringe. The guns never fill the carts up to the top and you end up spilling it constantly, because if you pull all the liquid up into it and there is a small bubble in the syringe, it will drip and leak constantly, covering your carts. Dont even bother, mine went straight in the bin after one use.

Thank you very much for the comment and all the info you mentioned brother.
I will decarb it, but only thing I didn't get is the part of seperating the terps from the Live Resin sauce, shouldn't just decarb it with low temp and keep the lid closed in order not to lose those terps? From videos I've seen, after decarbing it right it should be fluid enough to handle and fill in the carts.

The method I use is to decarb in a closed jar, or wrap it in tin foil if you can't find one without plastic/rubber on it as that can taint the mixture.

To separate terps in other ways, you can heat them up and they'll pool on the top

OR

You can use a centrifuge, but that's even more complicated.

Please note, as I said, it's tricky because if you have ANY, even a slight bit of the extract when you try to remove the terps, it will re-seed the extract and make it go crystalized again. So it's best to keep the lid sealed and keep it at a maximum of 101-102C

Couldn't be more thankful, much appreciated my friend!

I'd write that cart off personally - especially if you've got 40g.

Look up jartek decarb, get a hotplate stirrer.

I would not recommend trying to decarb all at once as it's easy to over do and you'll lose those precious terps.

Also stay well clear of any terpene diluent, if you're making pure live resin carts the only thing in that cart should be decarbed live resin.

If you need to thin it out use real canna derived terps and or CBC Distillate.

Thank u very much for your comment brother. I made a bit of research and I m gonna use jartek. hotplate stirrer is to place the jar after I finish with the oven right?
Would you have any suggestions on the time/temp needed? I'd prefer doing all 40g at once but since I m a newbie in this I should better make at least 2 batches.
Comments state that I should seperate the terps from my live resin sauce before decarbing it is that right?

No problem bud.

I use a hotplate to decarb instead of oven but honestly I don't think the heating source makes all the difference.

It's about temp and time.

Start around 90c for 1.5hrs using a small amount - 5g

The best way i believe is to use a centrifuge to mechanically separate the hte from the thca, then decarb only the thca. After that add the hte back and fill carts.

Check out 'howtoweed' on YouTube, all explained on there.

You need to pop the cap off and warm the extract enough for it to come out and then decarb it properly. Don't try to heat the cart itself, the pressure from heating the extract will cause it to leak. Howtoweed on YouTube has a guide to extract from carts I think.
Need to be careful though, if it's a pop cap and not a screw, if you apply too much pressure the glass will shatter.

Needs more decarbing if it's doing that

Can you put it in something waterproof and warm it up a bit in warm water? I've never encountered this before, sorry. Just a suggestion.

Never ever pay during US working hours!

35 dollars - a little vomit came up but you can't put a price on Xmas cheer

The fees are high atm for everyone mate,high fees and long wait getting your btc sent

That's rough, thank you. Glad to know it's not just me.

Traffic on the blockchain- btc is going to the moon.

Miners set their fees so that they charge whatever they want for the fastest speed. Transactions like ours are at the bottom of the pool. Imagine what someone trading $50m is prepared to pay for speed?

People sending half a BTC are paying $2k in fees. I can't be the only one that currently watches the blockchain in real time? Mempool.space is a great site. There was one wallet that has had trillions pumped through it. Probably best not to dig any deeper into that one...

Aye. Im watching Mempool today completely fucked off. After the last fee spike and the time it took to sort out, im not throwing anymore money into this stressful bs waiting game. Simply cant buy here, and DGT is about the only guy I wish to buy from anywhere. Its obscene that such a great idea is let down by the worst payment method you could imagine. Im just not using btc, anywhere, ever again

I bought as well today and it was £15 for mine 😩